タグ別アーカイブ: ルジール

    PXL_20260213_094731547
  • Fender Mexico ストラトキャスター PU交換&コンデンサ交換 Rugir Pickups’s

  • 2026/04/28
  • Category:
  • PXL_20260213_090134786

    フェンダーメキシコ製ストラトキャスターのPU交換・コンデンサ交換です。

    ルジール製のオーダーしたPUに交換です。

    過去にルジールでオーダーしたPUを使用し、そこから自分好みに寄せていくオーダーを数回繰り返しやっと希望通りのモデルが作れた様子です。
    音抜けが良くやや太めのサウンドで非常にバランスが良いリアPUになりました。

    ストラトキャスターのリアPUは皆様も困っていると思いますが、PU交換でリアが今度は「パワーが有り過ぎる」や「フロント・センターとのバランスが悪い」となる事が多いです。
    リアは「ほんの少しのパワーがほしい」はずですが、それを叶えてくれるPUが実はあまりありません。
    好みもあると思いますが、リアPUはポジションとして音が細くなるのでやや音の太さが欲しく、その太さに高域が負けるとリアとして旨みを失うので低音と高音のバランス感がある上で少しパワーが必要な特殊なポジションです。

    お客様の要望でコンデンサを0.022ufに交換しました。
    ポットのkΩ数・コンデンサの数値で音が変わってくるので自分好みに付け替えた方が良いです。
    この辺りに決まりはありません。

    ありがとうございました♪


    This is a pickup and capacitor replacement on a Fender Mexico Stratocaster.

    We’re replacing the pickups with custom-made ones from Luzil.

    It seems the owner used pickups previously ordered from Luzil, fine-tuning them to his liking through several iterations until he finally achieved the exact model he wanted.
    The result is a rear pickup with excellent projection, a slightly fuller tone, and excellent balance.

    I imagine many of you struggle with the Stratocaster’s bridge pickup; when replacing it, the bridge often ends up being “too powerful” or “out of balance with the neck and middle pickups.”
    Ideally, you’d want “just a little more power” from the bridge pickup, but there aren’t actually many pickups that can deliver that.
    Preferences vary, of course, but since the sound tends to get thinner in the bridge position, you want a bit of body. If the high frequencies overpower that body, the bridge loses its appeal, so it’s a unique position that requires a balance between low and high frequencies along with a bit of power.

    At the customer’s request, I replaced the capacitor with a 0.022uF unit.
    Since the sound changes depending on the pot’s resistance and the capacitor’s value, it’s best to swap them out to suit your own preferences.
    There are no set rules regarding this.

    Thank you very much♪


    〒114-0014 東京都北区田端1-21-3 エーデルワイス101

    ギターリペア工房 Draw a New Sound

    東京都 山手線 田端から徒歩2分 どこよりも早いリペア早期仕上げ対応可能のリーズナブル料金&丁寧な作業のギターリペアショップです♪

    ●ホームページ Draw a New Sound

    ●YouTubeではブログでは語られない裏話からギターの作り方まで掲載中! 
    マイチャンネル YouTubeチャンネル

    ●ツイッター DNS_Guitar




    PXL_20251130_090132683
  • Vanzandt ストラトキャスター PU交換&セットアップ Rugir Pickups’s

  • 2026/02/11
  • Category:
  • PXL_20251130_080033776

    ヴァンザンド製ストラトキャスターのPU交換・セットアップです。

    ルジールPUのオーダーPUをリアPUに交換です。

    ポールピースが調整できる仕様ですが製造上ピッチが狭い物しか作れないそうで、リアに付けると弦下にポールピース位置が来ません。

    ストラトのリアを太くした様な音で、通常のギラギラとした細いリアと比べ太さがあり音抜けがあって非常に良いと思います。
    モッサリ感があってマイルドなリアになるので耳に痛い音にならず使い易くなったと思います。

    ありがとうございました♪


    Vanzand Stratocaster pickup replacement and setup.

    Replacing the rear pickup with a custom-order Rujir pickup.

    Although the pole pieces are adjustable, apparently only narrow-pitch ones can be manufactured. When installed in the rear position, the pole piece position doesn’t align under the strings.

    It produces a sound reminiscent of a thickened Strat rear pickup. Compared to the typical bright, thin rear sound, this has more body and projection, which I think is excellent.
    It creates a mild, slightly muffled rear tone, avoiding harshness and making it much easier to use.

    Thank you very much! ♪


    〒114-0014 東京都北区田端1-21-3 エーデルワイス101

    ギターリペア工房 Draw a New Sound

    東京都 山手線 田端から徒歩2分 どこよりも早いリペア早期仕上げ対応可能のリーズナブル料金&丁寧な作業のギターリペアショップです♪

    ●ホームページ Draw a New Sound

    ●YouTubeではブログでは語られない裏話からギターの作り方まで掲載中! 
    マイチャンネル YouTubeチャンネル

    ●ツイッター DNS_Guitar




BLOG CATEGORY

ARCHIVE