I’d like a set consisting of Belden 19364 cable with Fulltec FI-11 and FI-C15 plugs.
Since I’m currently using 19364 cable in my own setup, I tested it out and found that even just the plugs alone give the sound a brighter, slightly harsher tone.
I’ve made cables using Marinko plugs and unplated connectors, but when using plated connectors, the sound shifts to emphasize the high frequencies.
This is an explanation of how to make power cables.
Power cables are parts that influence the sound, and there is a wide range of them from low-priced ones to expensive ones.
However, the production itself is very easy and flexible, so you can customize them to your own liking.
It is easy to think that making power cables is a difficult task, but it is not so unexpectedly.
When making a power cable, there is only one important thing to do: simply reconnect the power cable to the currently connected point.
When replacing only the plug, simply check the original power cable with a tester to note where the current is flowing, and replace the plug.
The plug is also just screwed on with a screwdriver, so all you have to do is use a wire stripper to face the wires and screw them back on.
When making power cables instead of replacing plugs, the price is through the roof, so basically anything will do depending on your budget, but the important minimum is “Are the cables shielded?” The minimum requirement is “Is it a cable with shielding effect?
Some cables have noise shielding and some do not, so choose power cables that are wrapped with aluminum or copper tape.
It is easily completed by stripping the wires and screwing them to the connector.
After this, if the power is restored to the same state as before, there is no problem.
Power cables are easy to make, so enjoy changing the sound by changing the plug or the cable itself.
It is known that the plating of the power plug has an effect on the sound.
Non-plated plugs tend to be treated as better, but sound is just a matter of taste, and non-plated plugs are good parts in the sense that they do not affect the sound, neither better nor worse.
Silver plating tends to lean toward the high frequencies, and the low frequencies are cut off and the sound becomes more sparkling, which disturbs the balance of the sound. If you like this sound, there is no problem, but many cables are marketed as “clearer sound” with this, so many brands are making money by fooling children.
Some inexpensive power cables are unplated on the equipment side and have aluminum tape wrapped around the cable, so simply replacing the outlet side with an unplated cable will improve the sound.
The important thing is to make sure that the grounding functions properly.
This is more important than improving the sound with power cables, and it is important to be able to ground the system.
This requires grounding of the building itself, which is not expensive and can be done for about 20,000 to 30,000 yen if you ask an electrician.
Alternatively, it is recommended to replace the wall outlet with a grounded 3-pin type, and connect it to the grounding wire near the refrigerator or washing machine.
